Enter each cut in the selected unit. Every cut is adjusted to the nearest product cutting point.
Choose a standard rectangular room or define an irregular shape with up to eight connected walls.
Walls use alternating 90° turns. Even numbers close the shape; odd numbers remain open.
Inches are shown for convenience. Strip cutting is precise in the metric system, so the entered value may be adjusted to the nearest permitted cutting point.
No cable selected. The maximum strip run is limited to power from one side.
We recommend a power supply with at least 10% reserve above the calculated strip power.
Enter a valid strip length to see suitable power supplies.
RF controllers are available with non-dimmable power supplies and are matched to the strip type and required wattage.
Two power supplies are recommended. For RF control, add one RF controller per power adapter — two RF controllers in total.
Select a non-dimmable power supply to see suitable RF controllers.
Remote interfaces are matched to the configured strip type.
Select an RF driver or controller to see suitable remote interfaces.